Electromagnetic flowmeters do not receive signals when they are measured or the signals are too weak. The causes of the problems and their handling are briefly described below.
First, the electromagnetic flow meter can not receive the signal when measured
If your electromagnetic flowmeter fails, we suggest that you can find, analyze and troubleshoot one by one by referring to the following sequence.
First, whether the medium in the measuring tube is full or not, whether the lining and the electrode are fouled, and whether all the cable connections are reliable;
Second, whether the grounding requirements are satisfied; whether the excitation coil is short-circuited or open circuited, and whether it is insulated from ground;
Third, whether the medium in the pipe system is leaking, whether the upstream and downstream valves are affected, and whether the installation position is appropriate;
Fourth, whether the surrounding environment has caused interference to the flowmeter; whether the converter fails.
Second, the electromagnetic flow meter can not receive the signal processing method
1. Verify that the tubing is full of fluid.
2. If the pipe is too close to the wall, install the probe on a pipe with a skewed angle, and instead of installing it on a horizontal pipe diameter, use the Z method to install the probe.
3. Carefully select the dense part of the pipe and polish it thoroughly, apply a sufficient amount of chelating agent to install the probe;
4. Carefully and carefully move each probe near the mounting point to find the maximum signal point to prevent the ultrasonic beam from reflecting the expected area due to fouling of the inner wall of the pipe or due to local deformation of the pipe and miss the possibility of receiving a stronger signal. Installation point
5. The metal pipe with serious fouling of the inner wall can be used to make the scaling part fall off or crack, but it should be noted that this method sometimes does not help ultrasonic transmission because of the gap between the scaling and the inner wall.
Maintenance of electromagnetic flowmeters should follow a certain order, so as to avoid entering the pitfalls of maintenance and causing unnecessary delays and losses. The electromagnetic flowmeter repair in the end what steps should be carried out is the best way to repair the electromagnetic flowmeter in the end what are the benefits, this is our use as an electromagnetic flowmeter instrumentation workers should consider, good quality electromagnetic flowmeter Normally, no routine maintenance is required. However, if the measured medium is likely to adhere or foul on the inner wall of the electrode and the measuring tube, the inner wall of the measuring tube and the electrode must be cleaned periodically, taking care not to damage the lining or the electrode.
In addition, regarding the re-check period of the electromagnetic flowmeter, it is recommended that the electromagnetic flowmeter be inspected once every two years. Users who require high accuracy should be submitted for inspection every year.
Taillight Wire Harness apply in automotive,motocycle,bus,bike,truck.
Yacenter has experienced QC to check the products in each process, from developing samples to bulk, to make sure the best quality of goods. Timely communication with customers is so important during our cooperation.
If you can't find the exact product you need in the pictures,please don't go away.Just contact me freely or send your sample and drawing to us.We will reply you as soon as possible.
Tail Light Wiring Harness,Trailer Wiring Harness,Trailer Light Wiring Kit,Trailer Light Harness
Dongguan YAC Electric Co,. LTD. , https://www.yacentercns.com