Run Hello under the bare metal, World [common error solution]

Development environment: Win7-64bit + ISE 14.4
Device: Zedboard
Hardware build diagram:

Run Hello under the bare metal, World [common error solution]

Run Hello under the bare metal, World [common error solution]

This article is the author's official document ZedBoard_CTT_v14.1_120821.pdf in the process of reading Xilinx, follow the steps described in the document to build the application step by step, but encountered some problems in it, and slightly obtained, search online Now, there are a lot of people who have encountered this problem, so sort it out, hope that people who do later can take less detours! Of course, the author is also a beginner, the level is limited, welcome everyone to criticize me!

1. Double-click PlanAhead to create a new project, as shown in Figure 1.

Run Hello under the bare metal, World [common error solution]

2, always follow the default operation.

Run Hello under the bare metal, World [common error solution]

As shown in Figure 3, set the name of the project and the location of the project, and keep pressing the default settings until Figure 4,

Run Hello under the bare metal, World [common error solution]

Run Hello under the bare metal, World [common error solution]

Select Boards and set the corresponding parameters as shown in Figure 5.

Run Hello under the bare metal, World [common error solution]

Then click next, as shown in Figure 6, click Finish. That is, the creation of the project is completed, and the window shown in Figure 7 pops up.

Run Hello under the bare metal, World [common error solution]

Run Hello under the bare metal, World [common error solution]

ShenZhen Fahold Electronic Limited , https://www.fahold.com